Concrete Raising and Leveling Missouri
Two of the most common methods of concrete repair in fixing these scenarios are mud jacking and polyjacking. This method has been repairing concrete driveways, sidewalks, patios and parking lots.
HOME >> Missouri
Concrete Repair and Leveling | Mudjacking
Cement Repair and Leveling
An uneven sidewalk not only looks bad, but it creates a tripping hazard. If the concrete slab is still intact, don’t waste your money on replacing the concrete.
In civil engineering, concrete leveling is a procedure that attempts to correct an uneven concrete surface by altering the foundation that the surface sits upon.
In order for your structure to be poured your whole lot needs to be dug out eight to ten feet deep. After the foundation has time to set, the hole around the structure is filled and the lawn is graded. The driveway, pathways, outdoor patios and also garage are then soaked the loose dirt.
Concrete Rasing Process
This process typically requires holes between 1″ and 2″ in diameter. This “mud” is injected under the concrete slabs, oftentimes using a movable pump that can access most slabs. Once the void under the slab is filled, the pressure builds under the slab, lifting the concrete back into place. Once in place, the holes are filled with a color-matching grout.
Benefits of Mudjacking
- Low-pressure lifting of slab
- Finely controlled lifting of the slab
- Complete filling of the void, without any air pockets
- Higher compressive strength than Foam Leveling
- Environmentally friendly
- Budget-friendly
Areas We Service Missouri:
- Affton
- Arnold
- Ballwin
- Belton
- Blue Springs
- Cape Girardeau
- Chesterfield
- Clayton
- Columbia
- Concord
- Creve Coeur
- Farmington
- Ferguson
- Florissant
- Fort Leonard Wood
- Gladstone
- Grandview
- Hannibal
- Hazelwood
- Independence
- Jackson
- Jefferson City
- Joplin
- Kansas City
- Kirksville
- Kirkwood
- Lake Saint Louis
- Lees Summit
- Lemay
- Liberty
- Manchester
- Maryland Heights
- Mehlville
- Nixa
- Oakville
- Ofallon
- O Fallon
- Old Jamestown
- Overland
- Ozark
- Polk
- Poplar Bluff
- Raymore
- Raytown
- Republic
- Rolla
- Saint Charles
- Saint Joseph
- Saint Louis
- Saint Peters
- Sedalia
- Sikeston
- Spanish Lake
- Springfield
- University City
- Warrensburg
- Webster Groves
- Wentzville
- Wildwood
- Bellefontaine Neighbors
- Bolivar
- Branson
- Bridgeton
- Carthage
- Crestwood
- Dardenne Prairie
- Eureka
- Excelsior Springs
- Festus
- Fulton
- Grain Valley
- Harrisonville
- Jennings
- Kennett
- Lebanon
- Marshall
- Maryville
- Mexico
- Moberly
- Neosho
- Saint Ann
- Town And Country
- Troy
- Union
- Washington
- Webb City
- West Plains
Concrete Leveling
In civil engineering, concrete leveling is a procedure that attempts to correct an uneven concrete surface by altering the foundation that the surface sits upon.
Self-leveling concrete has polymer-modified cement that has high flow characteristics and, in contrast to traditional concrete, does not require the addition of excessive amounts of water for placement.
A driveway is a type of private road for local access to one or a small group of structures, and is owned and maintained by an individual or group. Driveways rarely have traffic lights, but some that bear heavy traffic, especially those leading to commercial businesses and parks, do.
Concrete Leveling Services
Concrete Leveling
Concrete is a composite material composed of fine and coarse aggregate bonded together with a fluid cement (cement paste) that hardens (cures) over time.
Slabjacking
“Slabjacking” is a specialty concrete repair technology. In essence, slabjacking attempts to lift a sunken concrete slab by pumping a substance through the concrete, effectively pushing it up from below. The process is also commonly referred to as “mudjacking” and “pressure grouting.”
Accounts of raising large concrete slabs through the use of hydraulic pressure date back to the early 20th century. Early contractors used a mixture of locally available soils (sometimes including crushed limestone and/or cement for strength), producing a “mud-like” substance and thus the term “mudjacking.” In recent years, some slabjacking contractors began using expanding polyurethane foam. Each method has its benefits and disadvantages.
Causes of settlement
Concrete slabs can be susceptible to settlement from a wide variety of factors, the most common being an inconsistency of moisture in the soil. Soil expands and contracts as the levels of moisture fluctuate during the dry and rainy seasons.
What Our Customers Say About Our Concrete Leveling Work...
We're here to help! Call Us Today!
Concrete slabs can be susceptible to settlement from a wide variety of factors, the most common being an inconsistency of moisture in the soil. Soil expands and contracts as the levels of moisture fluctuate during the dry and rainy seasons. In some parts of the United States, naturally occurring soils can consolidate over time, including areas ranging from Texas up through to Wisconsin. Soil erosion also contributes to concrete settlement, which is common for locations with improper drainage. Concrete slabs built upon filled-in land can excessively settle as well. This is common for homes with basement levels since the backfill on the outside of the foundation frequently is not compacted properly. In some cases, poorly designed sidewalk or patio slabs direct water towards the basement level of a structure. Tree roots can also have an impact on concrete as well, actually powerful enough to lift a slab upwards or breakthrough entirely; this is common along public roadways, especially within metropolitan areas.
Concrete settlement, uneven concrete surfaces, and uneven footings can also be caused by seismic activity especially in the United States.
Slabjacking can typically be broken down into three main process types:
- Mudjacking.
- Limestone Grout Leveling.
- Expanding Structural Foam Leveling.